Framing Protruding Attic Wall

In evaluating wall framing you ll be looking for walls that are out of plumb or not flat or straight.

Framing protruding attic wall. Collar ties are horizontal members that like rafter ties extend from rafter to rafter but. As you shim and plumb each section of wall drive 16d nails through the top plate into the framing with a hammer or nail gun. Purchase enough to install a stud on each end of the wall and every 16 inches between. Set the header on the trimmers and nail through the king studs to hold it in place.

In wood framing basics and wall plans that have openings with cripples above the header cut and nail together the king studs and trimmers first. Score the shims with a utility knife and snap them off flush with the plate. Two by four lumber is standard for framing most walls including short walls in the attic. Then measure and nail the cripples into place.

Fasten the bottom plate by driving 16d nails through it into the floor. Nail the end studs to framing in the existing wall. Allow for a top and. If you see protruding drywall in a tall wall look to see if it s at the same height as the floor joists.

If you want your attic space to have a flat ceiling you ll need to add collar ties to the framing. Then position and nail them to the plates. Use screws to attach sheets of birch plywood to the angled ceiling over the insulation making sure to drive the screws into the ceiling joists.